Plug-in quick-release connector
Clippard Push-Quick Fittings provide a simple method of connecting pneumatic components to each
other and system piping. They are designed for use with both flexible hose and stiff tubing made of nylon, urethane, polyethylene or polypropylene. Push-Quick Fittings generally provide higher flows than barbed fittings. The Push- Quick fitting allows full flow through the hose/tubing I.D. with no smaller orifice required as in barb fittings. The chart shows the comparison between barb and push in fittings for various tubing/hose sizes. Push-Quick Fittings are available in nine sizes for 1/8”, 5/32”, 6 mm, 1/4” and 3/8” O.D. tubing. The 5/32” fittings may also be used with 4 mm O.D. tubing.
Installation of Tubing into fitting
1. Slowly push a clean and perpendicularly cut tubing into the fitting until it comes
to a dead stop.
2. Pull the tubing back gently until the Gripper Ring of the fitting grips onto the
tubing and has a good seal.
Removal of Tubing from fitting

1. Push in evenly on the two long oval sides of the Release

Button.

2. Pull out the tubing while keeping the Release Button

depressed.

3. To reuse the tubing; cut off the lodged portion of the

previously used tubing evenly and perpendicularly.

Installation of Pipe Fittings with Pre-Applied sealant

1. Tighten fitting by hand, then turn it 2 or 3 turns with a wrench

until it reaches the desired torque listed.

2. If the fitting is used and the sealant coating is not in good condition, apply

Teflon® sealant tape to the threads